Logo
10.07.2019

Article

Flow Meters Help Refineries Optimise Output of Sulfur Recovery Units

Process engineers at oil & gas refineries will find that the rugged ST100 Thermal Mass Flow Meter Series from Fluid Components International (FCI) provides highly accurate, dependable measurement of air and fuel gases to optimise the performance of the boilers utilised by sul...

read...
Logo
16.01.2019

Article

Optimizes Air Flow Control for Operation of Industrial Blowers and Dryers

Engineers responsible for the efficient operation of industrial air blowers and dryers used in raw materials production will find the ST50 Mass Flow Meter Series from Fluid Components International (FCI) beneficial as it provides precision measurement of air to increase the effic...

read...
Logo
02.02.2018

Article

Ideal for Automated Assembly Lines and End-To-End Packaging Machinery

Machinery manufacturers and plant engineers relying on the pneumatic control of automated assembly lines and end-to-end packaging equipment can reduce their operational compressed air energy costs significantly with the highly repeatable and dependable FS10i Flow Switch Monitor f...

read...
Logo
22.03.2017

Article

Avoid Costly Pump Repairs, Reduce Maintenance and Extend Life

Engineers responsible for municipal or industrial water storage, disinfection or effluent treatment systems will find the FlexSwitch® FLT93 Flow Switch from Fluid Components International (FCI) reduces pump repair and extends pump life by detecting dry running conditions.

read...
Logo
16.03.2016

Article

Solar Powered Flow Meters Provide Flare Gas Measurement for Remote Fracking Sites

Engineers responsible for oil/gas production at remote field sites that lack easy access to electric power will find constant power technology thermal mass flow meters from Fluid Components International (FCI) can provide a solution to their gas flow metering needs.

read...
Logo
10.04.2015

Article

Precise Flow Measurement with On-Site Calibration

The new ST100 Series Thermal Mass Flow Meter from Fluid Components International (FCI) with FCI’s Verical In-Situ Calibration Verification System combines precise air/gas measurement capability with the convenience of in-situ calibration verification.

read...
Logo
28.05.2014

Article

New Flow Conditioner Removes Swirl For Accurate Mag Meter Measurement

The Vortab Company offers Vortab Elbow Flow Conditioner that eliminates the problem by removing swirl and asymmetric velocity profiles caused by pumps placed too close to the meter. This helps Wastewater treatment engineers find room for the recommended straight pipe run needed b...

read...
Logo
14.05.2010

Article

Gas Flowmeter for Hazardous Areas

The ST75 thermal dispersion gas flowmeter from Fluid Components International (FCI) is now Atex and IECEx approved for potentially explosive environments.

read...